Dodge Journey: Lamps Lighting - Exterior
Dodge Journey Service & Repair Manual / Accessories and Equipment / Lamps Lighting - Exterior
- Description
- Operation
- Diagnosis and Testing
- Standard procedure
- Cam, turn signal cancel
- Lamp, center high mounted stop
- Lamp, fog, front
- Lamp, fog, rear export
- Lamp, license plate
- Lamp, side repeater, export
- Lamp, tail stop turn
- Motor, headlamp leveling, export
- Relay, trailer tow
- Switch, backup lamp
- Switch, hazard warning
- Switch, headlamp leveling, export
- Switch, multifunction, left
- Switch, parking brake
- Switch, stop lamp
- Unit, front lamp
- Wiring, trailer tow
Pod, switch
DESCRIPTION
Fig. 10: Accessory Switch Bank Module
The Accessory Switch Bank Module (ASBM) is located in the center stack area
of the instrument panel just
below the heater and air conditioner d ...
Description
Fig. 1: Exterior Lighting System
The exterior lighting system for this vehicle includes the following exterior
lamp units:
Center High Mounted Stop Lamp (3) - A standard equipment Center High ...
See also:
Installation
FRONT
NOTE: Inspect disc brake pads before installation.
Fig. 169: VENTED BRAKE ROTOR MOUNTING
1. Clean the hub face (1) to remove any dirt or corrosion where the rotor
mounts.
2. Insta ...
REMOTE SOUND SYSTEM CONTROLS — IF
EQUIPPED
The remote sound system controls are located on the rear
surface of the steering wheel. The left and right-hand
controls are rocker-type switches with a pushbutton in
the center of each switch. Rea ...
Installation
1. Completely retract the caliper piston back into the bore of the caliper.
Use a C-clamp to retract the piston.
Place a wood block over the piston before installing the C-clamp to avoid
damagi ...
