Removal, Installation

REMOVAL WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering co ...

Description, Operation

DESCRIPTION There are two unique park brake switches used on this vehicle, depending upon whether the vehicle has a foot-operated or hand-operated park brake lever mechanism. FOOT-OPERATED Fi ...

See also:

Installation
NOTE: Perform 1 through 6 on each side of vehicle to complete pad set installation, then proceed to 7. CAUTION: Anytime the brake rotor or brake pads are being replaced, the rear cal ...

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructions may result in serious or fat ...

Assembly
Fig. 239: Output Shaft #2 & Needle Bearing 1. Install the reverse needle bearing (1) onto the output shaft # 2 (2). Fig. 240: Synchronizer NOTE: Pay attention to the direction when inser ...