Installation

2.0L TURBO DIESEL Fig. 19: Generator Bushing 1. If reinstalling the old generator, install a generator mounting bolt and tap bushing out slightly to ease mounting of generator. Fig. 20: Remo ...

2.7L DOHC Engine

...

See also:

Disassembly
Fig. 200: Snap Ring At Output Shaft Case Bearing 1. Remove the snap ring (2) from the output shaft. Fig. 201: Output Shaft Case Bearing And Gear 2. Use Bearing Splitter P-334 (3), Cage 8925-3 ( ...

Disassembly
NOTE: The rear heater-A/C housing must be removed from the vehicle for service of the mode door actuator and blend door actuator and it must be disassembled for service of the A/C evaporator ...

Installation
Fig. 25: Ball Joint Installation 1. Install Installer (2), Special Tool 9964-1, and Installer (4), Special Tool 9964-2 on Remover/Installer (5), Special Tool 8441-1. Place a new ball joint (stem ...