Adjustments

ADJUSTMENT - LATE PRODUCTION TYPE ONLY Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not ...

Standard procedure, Removal

STANDARD PROCEDURE FRONT LAMP UNIT MOISTURE CLEARING Some occasional moisture accumulation inside a vented front lamp unit is normal and appears as a fogging on the inside of the lamp lens, simil ...

See also:

Manifold, exhaust, front
Removal 1. Disconnect negative battery cable. 2. Remove the engine cover. Fig. 295: Oxygen Sensors 3. Disconnect and remove oxygen sensors (2) and (4). Fig. 296: Upper Maniverter Heat Shiel ...

Engine oil leak inspection
Begin with a thorough visual inspection of the engine, particularly at the area of the suspected leak. If an oil leak source is not readily identifiable, the following steps should be followed: 1. ...

Standard Procedure
MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...