Electronically controlled clutch

REMOVAL NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues. Fig. 95: Removing /Installing Propell ...

Battery System

...

See also:

Adjustments
ADJUSTMENT - LATE PRODUCTION TYPE ONLY Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not ...

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

Disassembly
NOTE: Cleanliness through entire disassembly and assembly of the valve body cannot be overemphasized. When disassembling, each part should be washed in a suitable solvent, then dried by comp ...