Dodge Journey: Switch, stop lamp

Removal, Installation
REMOVAL WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering co ...

Description, Operation
DESCRIPTION Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not interchangeable and both a ...

See also:

Installation
NOTE: Perform 1 through 6 on each side of vehicle to complete pad set installation, then proceed to 7. CAUTION: Anytime the brake rotor or brake pads are being replaced, the rear cal ...

Removal
1. Raise and support the vehicle. 2. If equipped, remove the engine belly pan. 3. Remove the rear engine mount. 4. Remove the front engine mount through-bolt. Fig. 66: Stabilizer Link Mo ...

Description, Diagnosis and Testing
DESCRIPTION This vehicle is equipped with either an equal length halfshaft system, consisting of short halfshafts on both sides with an intermediate drive shaft on the right side, or an unequal le ...

0.0158