Installation

1. Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston before installing the C-clamp to avoid damagi ...

Removal

1. Disconnect and isolate battery negative cable from battery post. Fig. 70: BRAKE PEDAL HOLDING TOOL 2. Using a brake pedal holding tool as shown, depress brake pedal past its first inch of tra ...

See also:

Sensor, exhaust temperature
REMOVAL EXHAUST TEMPERATURE SENSOR Fig. 44: Exhaust Temperature Sensor - DPF TEMPERATURE SENSOR ELECTRICAL CONNECTOR - DPF TEMPERATURE SENSOR 1. Remove engine cover. 2. Disconnect and ...

Installation
LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...

Removal
Fig. 393: Removing/Installing Defroster Cover 1. Disconnect the negative battery cable. 2. Using a trim stick remove the defroster cover (1). Fig. 394: Removing/Installing Screws At Center St ...