Lamp, side repeater, export

REMOVAL BULB NOTE: Side repeater lamps are used only on vehicles manufactured for certain export markets where they are required. Fig. 20: Remove/Install Repeater Lamp Bulb 1. Disconne ...

Removal

BULB Each rear lamp unit for this vehicle consists of two pieces. An outer rear lamp unit that is secured at the rear of each quarter panel includes bulbs for the park (or tail) lamps, the brake ( ...

See also:

Installation
BEVERAGE COOLER NOTE: LHD model shown in illustrations. RHD model similar. OUTLET Fig. 149: Beverage Cooler Outlet & Hose NOTE: If the beverage cooler cold air supply hose falls back ...

Installation
LEFT-HAND DRIVE 1. Clean any debris off the mating surfaces of the HCU and ABM. CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant. ...

Diagnosis and testing
SHIFT INTERLOCK SYSTEM Fig. 421: Identifying Ignition Key/Switch Positions - LOCK - ACC - ON - START The Shifter Response Table describes the normal operation of the Brak ...