Dodge Journey: DRIVING THROUGH WATER

Driving through water more than a few inches/ centimeters deep will require extra caution to ensure safety and prevent damage to your vehicle.

Flowing/Rising Water

WARNING:
Do not drive on, or cross, a road or a path where water is flowing and/or rising (as in storm run-off).

Flowing water can wear away the road or path’s surface and cause your vehicle to sink into deeper water. Furthermore, flowing and/or rising water can carry your vehicle away swiftly. Failure to follow this warning may result in injuries that are serious or fatal to you, your passengers, and others around you.

Shallow Standing Water

CAUTION:
• Always check the depth of the standing water before driving through it. Never drive through standing water that is deeper than the bottom of the tire rims mounted on the vehicle.

• Determine the condition of the road or the path that is under water, and if there are any obstacles in the way, before driving through the standing water.

• Do not exceed 5 mph (8 km/h) when driving through standing water. This will minimize wave effects.

CAUTION:
• Driving through standing water may cause damage to your vehicle’s drivetrain components. Always inspect your vehicle’s fluids (i.e., engine oil, transmission, axle, etc.) for signs of contamination (i.e., fluid that is milky or foamy in appearance) after driving through standing water. Do not continue to operate the vehicle if any fluid appears contaminated, as this may result in further damage.

Such damage is not covered by the New Vehicle Limited Warranty.

• Getting water inside your vehicle’s engine can cause it to lock up and stall out, and cause serious internal damage to the engine. Such damage is not covered by the New Vehicle Limited Warranty.

WARNING:
• Driving through standing water limits your vehicle’s traction capabilities. Do not exceed 5 mph (8 km/h) when driving through standing water.

• Driving through standing water limits your vehicle’s braking capabilities, which increases stopping distances. Therefore, after driving through standing water, drive slowly and lightly press on the brake pedal several times to dry the brakes.

• Getting water inside your vehicle’s engine can cause it to lock up and stall out, and leave you stranded.

• Failure to follow these warnings may result in injuries that are serious or fatal to you, your passengers, and others around you.

    DRIVING ON SLIPPERY SURFACES
    Acceleration Rapid acceleration on snow covered, wet, or other slippery surfaces may cause the front wheels to pull erratically to the right or left. This phenomenon occurs when there is a differe ...

    POWER STEERING
    The standard power steering system will give you good vehicle response and increased ease of maneuverability in tight spaces. The system will provide mechanical steering capability if power assist ...

    See also:

    Module, final drive control
    DESCRIPTION The AWD ECM (electronic control module) mounts on the driver side cowl side panel, where it is concealed by the instrument panel. It communicates with other systems over the high-speed ...

    Lever, shift
    REMOVAL Fig. 183: Air Cleaner And Inlet Tube Remove the engine cover. 1. Disconnect battery negative cable. 2. Remove air inlet tube (2) and air cleaner assembly (4). Fig. 184: Nut Crosso ...

    Description, Operation
    DESCRIPTION Fig. 1: Battery Components This vehicle is equipped with a single 12-volt battery. All of the components of the battery system are located in the front of the vehicle, just ahead of ...

    0.0162