Dodge Journey: STARTING AND OPERATING
Dodge Journey Owners Manual / STARTING AND OPERATING
- STARTING PROCEDURES
- ENGINE BLOCK HEATER — IF EQUIPPED
- AUTOMATIC TRANSMISSION
- AUTOSTICK — IF EQUIPPED
- ALL WHEEL DRIVE (AWD) — IF EQUIPPED
- DRIVING ON SLIPPERY SURFACES
- DRIVING THROUGH WATER
- POWER STEERING
- PARKING BRAKE
- BRAKE SYSTEM
- ELECTRONIC BRAKE CONTROL SYSTEM
- TIRE SAFETY INFORMATION
- TIRES — GENERAL INFORMATION
- TIRE CHAINS
- SNOW TIRES
- TIRE ROTATION RECOMMENDATIONS
- TIRE PRESSURE MONITOR SYSTEM (TPMS)
- FUEL REQUIREMENTS
- ADDING FUEL
- VEHICLE LOADING
- TRAILER TOWING
- RECREATIONAL TOWING (BEHIND MOTORHOME, ETC.)
CLIMATE CONTROLS
The Climate Control System allows you to regulate the
temperature, amount, and direction of air circulating
throughout the vehicle. The controls are located in the
center stack of the instrument pa ...
STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust the
inside and outside mirrors, fasten your seat belt, and if
present, instruct all other occupants to buckle their seat
belts.
WARNING:
Nev ...
See also:
Heater performance
Before performing the following tests, see COOLING for the procedures to
check the engine coolant level and
flow, engine coolant reserve/recovery system operation, accessory drive belt
condition ...
Assembly
Fig. 239: Output Shaft #2 & Needle Bearing
1. Install the reverse needle bearing (1) onto the output shaft # 2 (2).
Fig. 240: Synchronizer
NOTE: Pay attention to the direction when inser ...
Standard procedure
ENGINE GASKET SURFACE PREPARATION
Fig. 4: PROPER TOOL USAGE FOR SURFACE PREPARATION
To ensure engine gasket sealing, proper surface preparation must be
performed, especially with the use of
alu ...
