Dodge Journey: Strut, suspension, assembly

Installation
NOTE: Before stabilizer bar installation, inspect the cushions and links for excessive wear, cracks, damage and distortion. Replace any pieces failing inspection. NOTE: Before installing the ...

Description, Operation
DESCRIPTION A Macpherson type design strut assembly is used in place of the traditional front suspension upper control arm and upper ball joint. The bottom of the strut mounts directly to the stee ...

See also:

Speed Control
SWITCH, SPEED CONTROL REMOVAL Fig. 1: Removing/Installing Horn Switch WARNING: Disconnect and isolate the battery negative (ground) cable before beginning steering wheel removal or ...

TO OPEN AND CLOSE THE HOOD
Two latches must be released to open the hood. 1. Pull the hood release lever located under the left side of the instrument panel. Hood Release 2. Outside of the vehicle, locate the safety latch ...

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

0.3951