Installation

2.4L Fig. 52: 2.4L Knock Sensor CAUTION: Always torque knock sensors to the correct torque specification. Over or under tightening effects knock sensor performance. Ensure the electr ...

Removal

2.4L Fig. 59: Identifying Ignition Coil Electrical Connectors NOTE: Prior to removing coil, spray compressed air around coil top to make sure no dirt drops into the spark plug tube. 1. ...

See also:

Actuator, mode door, front
DESCRIPTION Fig. 12: Blend Door Actuators The mode door actuator (1) for the heating-A/C system is a reversible, 12-volt Direct Current (DC) servo motor, which is mechanically connected to the ...

Disassembly
Fig. 229: Snap Ring At Output Shaft 1. Using Snap Ring Pliers (1) remove the snap ring (2) from the output shaft # 2. Fig. 230: Bearing From Cluster Shaft 2. Using a press, blocks, Bearing Sp ...

Cooler, EGR
Description Fig. 62: EGR COOLER - EGR COOLER TO EGR VALVE TUBE - MOUNTING SCREWS - EGR COOLER MOUNTING SCREW - MOUNTING SCREW - EGR COOLER BODY - EGR COOLER MOUNTING NUT - EGR COOLE ...