Installation

2.4L FRONT Fig. 38: Removing/Installing Camshaft Position Sensor CAUTION: Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do n ...

Removal

2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...

See also:

Removal
NOTE: Before proceeding, review all Warnings and Cautions. 1. Raise and support the vehicle. Fig. 16: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts (3), then the tire and wheel a ...

Filter, particulate air
Description Fig. 85: Filter-Particulate Air Description Some models are equipped with a particulate air filter (1) that helps purify the outside air entering the HVAC housing. The filter is mou ...

Task manager
Description The PCM is responsible for efficiently coordinating the operation of all the emissions-related components. The PCM is also responsible for determining if the diagnostic systems are ope ...