Plug, glow

DESCRIPTION Fig. 26: Glow Plug Glow plugs are used to help start a cold or cool engine. The glow plugs will heat up and glow to heat the combustion chamber of each cylinder. An individual glow ...

Operation, Removal

OPERATION CAMSHAFT AND CRANKSHAFT SIGNALS Fig. 29: 4 Cylinder Cam & Crank Signals NOTE: The graphic represents the relationship between camshaft and crankshaft sensors edges with cams ...

See also:

Diagnosis and Testing
BRAKE ROTOR Any servicing of the rotor requires extreme care to maintain the rotor within service tolerances to ensure proper brake action. Excessive runout or wobble in a rotor can increase pe ...

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...