Dodge Journey: Valve, oil pressure relief

Removal

2.7L DOHC Engine
Fig. 285: Oil Pressure Relief Valve

  1. - RELIEF VALVE
  2. - SPRING
  3. - RETAINER CAP

1. Remove the oil pan.

2. Remove the pressure relief valve (1) by remove the threaded retaining cap from the oil pump housing.

CAUTION: Oil pump pressure relief valve must be installed as shown in illustration or engine damage may occur.

3. Remove spring and relief valve.

Installation

2.7L DOHC Engine
Fig. 286: Oil Pressure Relief Valve

  1. - RELIEF VALVE
  2. - SPRING
  3. - RETAINER CAP

1. Lubricate relief valve with oil.

CAUTION: The pressure relief valve must be installed as shown in illustration or engine damage may occur.

2. Install relief valve (1) , spring and retainer cap. Tighten cap to 12 N.m (105 in. lbs.).

3. Install the oil pan.

    Switch, oil pressure
    Description The engine oil pressure switch is located on the right side of the engine block. The switch screws into the engine main oil gallery. The normally closed switch provides an input throug ...

    Manifolds
    ...

    See also:

    REPORTING SAFETY DEFECTS
    In the 50 United States and Washington, D.C. If you believe that your vehicle has a defect that could cause a crash or cause injury or death, you should immediately inform the National Highway Traf ...

    Switch, defogger, rear
    DESCRIPTION Fig. 5: EBL Switch (MTC) NOTE: Manual tri-zone temperature A/C-heater control shown in illustration. Other A/Cheater controls similar. The momentary push-button swi ...

    Lifter(s), hydraulic
    Diagnosis and Testing DIAGNOSIS AND TESTING - HYDRAULIC LASH ADJUSTER NOISE DIAGNOSIS Proper noise diagnosis is essential in locating the source of a NVH complaint. Locating a lash adjuster (tappe ...


    0.0216