Dodge Journey: Seal(s), valve guide
REMOVAL
Fig. 139: Valve Stem Seal-Removal/Installation
- - VALVE SEAL TOOL
- - VALVE STEM
1. Remove valve spring.
2. Remove valve stem seal by using a valve seal tool.
INSTALLATION
Fig. 140: Valve Stem Seal-Removal/Installation
- - VALVE SEAL TOOL
- - VALVE STEM
1. The valve stem seal/valve spring seat should be pushed firmly and squarely over the valve guide using the valve stem as guide. Do Not Force seal against top of guide.
2. Install valve spring.
Rocker arm, valve
DESCRIPTION
Fig. 133: Rocker Arm
- LASH ADJUSTER POCKET
- OIL SQUIRT HOLE
- ROLLER
The rocker arms are composed of steel stamping with an integral roller
bearing. The rocker arms incor ...
Spring(s), valve
Description
The valve springs are made from high strength, chrome-silicon steel. The
springs are common for intake and
exhaust applications. The valve spring seat is integral with the valve stem
...
See also:
Removal, Installation
REMOVAL
WARNING: Refer to the applicable warnings and cautions for this
system before
performing the following operation. Failure to follow the warnings and
cautions may result in po ...
Installation
1. Guide the trailing end of the parking brake cable along the inboard side
of the axle trailing arm up to the
rear brake caliper. Make sure the cable is routed between the brake line and the
tra ...
SUGGESTIONS FOR OBTAINING SERVICE FOR YOUR VEHICLE
Prepare For The Appointment
If you’re having warranty work done, be sure to have the
right papers with you. Take your warranty folder. All
work to be performed may not be covered by the
warranty ...
