Installation

Fig. 28: Sealing Boot Installation on Interconnecting Shaft - SEALING BOOT - RAISED BEAD IN THIS AREA OF SEALING BOOT - GROOVE - INTERCONNECTING SHAFT 1. Slide new sealing boot clamp (2 ...

Description, Diagnosis and Testing

DESCRIPTION The inner joints of both half shaft assemblies are tripod joints. The outer joints of both assemblies are Rzeppa Joints. The tripod joints are true constant velocity (CV) joint assembl ...

See also:

Installation
2.4L Fig. 52: 2.4L Knock Sensor CAUTION: Always torque knock sensors to the correct torque specification. Over or under tightening effects knock sensor performance. Ensure the electr ...

Disassembly
Fig. 229: Snap Ring At Output Shaft 1. Using Snap Ring Pliers (1) remove the snap ring (2) from the output shaft # 2. Fig. 230: Bearing From Cluster Shaft 2. Using a press, blocks, Bearing Sp ...

Plug, glow
DESCRIPTION Fig. 26: Glow Plug Glow plugs are used to help start a cold or cool engine. The glow plugs will heat up and glow to heat the combustion chamber of each cylinder. An individual glow ...