Dodge Journey: Amplifier

DESCRIPTION

The optional premium speaker system includes a separate audio power amplifier. The amplifier is an eight channel unit. The amplifier is located behind the right cowl trim panel.

OPERATION

The power amplifier electronically increases the frequency response of the normal audio signal output from the radio amplifier in order to improve the acoustic performance of the speakers. On vehicles equipped with an amplifier, the amplifier information of the radio becomes a pre-amplifier.

The amplifier receives audio signal inputs for speaker channels from the radio, then sends amplified audio outputs through eight separate channels with dedicated feed and return circuits to the individual speakers.

REMOVAL

Audio and Video
Fig. 1: Amplifier

1. Disconnect and isolate the battery negative cable.

2. Lower the glove box as necessary to gain access to the amplifier.

3. Disconnect the electrical connectors.

4. Loosen the mounting fasteners and remove the amplifier and bracket.

5. Remove the amplifier from the bracket.

INSTALLATION

Audio and Video
Fig. 2: Amplifier

1. Install the amplifier to the mounting bracket.

2. Install amplifier. Tighten the forward screw to 3 N.m (26.5 in. lbs.) and the rear nut to 2 N.m (18 in. lbs.).

3. Connect the electrical connectors.

4. Raise the glove box.

5. Connect the battery negative cable.

    Diagnosis and Testing
    Video VIDEO SYSTEM DIAGNOSIS CONDITION POSSIBLE CAUSES CORRECTION NO VIDEO (DVD PLAYER WILL NOT LOAD OR EJECT) 1. Fuse inoperative. 1. Check fuses. Replace fuse ...

    Antenna, satellite, audio, video
    ANTENNA, SATELLITE, AUDIO DESCRIPTION Fig. 3: Satellite Audio If the vehicle is equipped with satellite audio, a combined antenna for AM/FM and satellite is used. For removal. See Removal and ...

    See also:

    Crankshaft
    Description The crankshaft is constructed of a forged micro alloy steel. The six throw, nine counterweight crankshaft is supported by four select fit main bearings with the number three serving as ...

    Removal
    WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructions may result in serious or fat ...

    Installation
    NOTE: Perform 1 through 6 on each side of vehicle to complete pad set installation, then proceed to 7. CAUTION: Anytime the brake rotor or brake pads are being replaced, the rear cal ...

    0.0102