Dodge Journey: Controls, front
Dodge Journey Service & Repair Manual / Heating & Air Conditioning / Controls, front
- Actuator, blend door, front
- Actuator, mode door, front
- Actuator, recirculation door
- Control, A/C and heater, front
- Module, power, front blower motor
- Resistor, blower motor, front
- Sensor, ambient temperature
- Sensor, evaporator temperature
- Sensor, infrared temperature
- Sensor, sun
- Transducer, A/C pressure
Heater performance
Before performing the following tests, see COOLING for the procedures to
check the engine coolant level and
flow, engine coolant reserve/recovery system operation, accessory drive belt
condition ...
See also:
Removal
2.4L
Fig. 45: Locating Knock Sensor
The knock sensor bolts into the side of the cylinder block in front of the
starter under the intake manifold.
1. Disconnect and isolate negative battery ca ...
Seal, axle drive shaft
REMOVAL
Fig. 197: Axle Shaft Seal Removal
1. Remove axle shaft.
2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1).
3. Tap on the pry tool (2) with a small hammer and ...
Description, Operation
DESCRIPTION
A Macpherson type design strut assembly is used in place of the traditional
front suspension upper control arm
and upper ball joint. The bottom of the strut mounts directly to the stee ...
