Installation

2.4L Fig. 52: 2.4L Knock Sensor CAUTION: Always torque knock sensors to the correct torque specification. Over or under tightening effects knock sensor performance. Ensure the electr ...

Removal

2.4L Fig. 59: Identifying Ignition Coil Electrical Connectors NOTE: Prior to removing coil, spray compressed air around coil top to make sure no dirt drops into the spark plug tube. 1. ...

See also:

Tube, water inlet
Removal WATER INLET TUBE Fig. 126: WATER PUMP INLET TUBE WORLD ENGINE - NUTS - WATER PUMP INLET TUBE - WATER PUMP HOUSING The water pump inlet tube (2) connects the water pump to the co ...

Removal
Fig. 2: Engine Cover Remove the engine cover. 1. Disconnect battery negative cable. 2. Remove air inlet tube (2) and air cleaner assembly (4). Fig. 3: Bleeder At Slave Cylinder 3. Remove ...

REPLACEMENT BULBS
All the inside bulbs are brass or glass wedge base. Aluminum base bulbs are not approved and should not be used for replacement. LIGHT BULBS – Interior Bulb Number Courtesy/Reading Lamps (Incand ...