Installation

2.4L FRONT Fig. 38: Removing/Installing Camshaft Position Sensor CAUTION: Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do n ...

Removal

2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...

See also:

Installation
CAUTION: When installing a NEW brake caliper it is necessary to bleed the brakes using a special procedure which has been integrated to this installation procedure. Fig. 76: R ...

Standard procedure
REFRIGERANT SYSTEM SERVICE EQUIPMENT WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructio ...

Module, power, rear blower motor
DESCRIPTION Fig. 59: Rear Blower Power Module Description A blower motor power module is used on this model when equipped with the automatic temperature control (ATC) rear heating-A/C system. M ...