Installation

LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...

Removal

1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

See also:

Seal, oil pump
REMOVAL Fig. 367: Removing Oil Pump Seal - SEAL PULLER C-3981-B - OIL PUMP SEAL 1. Remove transaxle from vehicle. 2. Using Seal Puller C-3981B (1) , remove oil pump seal (2). INSTALLA ...

Installation
NOTE: Perform 1 through 5 on each side of the vehicle to complete pad set installation, then proceed to 6. NOTE: Make sure that the audible wear indicator (if equipped) is placed toward ...

Removal, Installation
REMOVAL WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions may result in po ...