Resistor, blower motor, rear

DESCRIPTION Fig. 62: Rear Blower Resistor A blower motor resistor is used on this model when equipped with the manual temperature control (MTC) rear heating-A/C system. Models equipped with the ...

Duct, defroster

REMOVAL WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negat ...

See also:

Cover(s), engine timing
Removal Fig. 349: FRONT SPLASH SHIELDS 1. Disconnect and isolate negative battery cable. 2. Drain cooling system. 3. Remove coolant pressure container. 4. Remove right front wheel and bel ...

Electronically controlled clutch
REMOVAL NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance issues. Fig. 95: Removing /Installing Propell ...

Crankshaft
Description The crankshaft is constructed of a forged micro alloy steel. The six throw, nine counterweight crankshaft is supported by four select fit main bearings with the number three serving as ...