Removal, Installation

REMOVAL WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negati ...

Description

Fig. 142: Instrument Panel Outlets There are two defroster air outlets (1) in the defroster grille (2) located at the top of the instrument panel. The airflow from the defroster outlets are dire ...

See also:

Lamp, center high mounted stop
REMOVAL Fig. 5: Center High Mounted Stop Lamp 1. Disconnect and isolate the battery negative cable. 2. Remove the two screws (4) that secure the Center High Mounted Stop Lamp (CHMSL) (3) to t ...

Removal
LEFT-HAND-DRIVE CAUTION: The vacuum in the power brake booster must be pumped down before removing the master cylinder to prevent the booster from sucking in any contamination. This ...

Assembly
Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...