Adjustments

ADJUSTMENT - LATE PRODUCTION TYPE ONLY Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not ...

Standard procedure, Removal

STANDARD PROCEDURE FRONT LAMP UNIT MOISTURE CLEARING Some occasional moisture accumulation inside a vented front lamp unit is normal and appears as a fogging on the inside of the lamp lens, simil ...

See also:

Description, Operation
DESCRIPTION The generator is belt-driven by the engine. It is serviced only as a complete assembly. If the generator fails for any reason, the entire assembly must be replaced. The generator produ ...

Installation
NOTE: Perform 1 through 6 on each side of vehicle to complete pad set installation, then proceed to 7. CAUTION: Anytime the brake rotor or brake pads are being replaced, the rear cal ...

Removal
LEFT-HAND DRIVE NOTE: The ABM is only separately serviceable for non-HSA (Hill Start Assist) equipped vehicles. Do not remove the ABM for vehicles equipped with HSA. 1. Disconnect the nega ...