Dodge Journey: REPLACEMENT BULBS

All the inside bulbs are brass or glass wedge base.

Aluminum base bulbs are not approved and should not be used for replacement.

LIGHT BULBS – Interior Bulb Number

Courtesy/Reading Lamps (Incandescent). . . . . . . . 578. Courtesy/Reading Lamps. (Optional LED) . . . . . . . . . . . . . . . . . . . . . . . . . LED. (Serviced at Authorized Dealer). Glove Box Lamp . . . . . . . . . . . . . . . . . . . . . . . . . 194. Cargo Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . 579. Optional Door Map. Pocket/Cupholder . . . . . . . . . . . . . . . . . . . . . . . LED. (Serviced at Authorized Dealer).

LIGHTS BULBS – Exterior Bulb No.

Low Beam Headlamp. . . . . . . . . . . . . . . . . . . . . 9006.

High Beam Headlamp . . . . . . . . . . . . . . . . . . . . 9005.

Front Park/Turn Signal . . . . . . . . . . . . . . . . . 3757AK.

Side Marker Lamp. . . . . . . . . . . . . . . . . . . . . . . . 168.

Front Fog Lamp . . . . . . . . . . . . . . . . . . . . . . PSX24W.

Center High Mounted Stop Lamp (CHMSL) . . . . . . . LED (Serviced at Authorized Dealer) Rear Tail/Stop/Turn Signal . . . . . . . . . . . . . . . 3157K.

Rear Tail . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3157K.

Backup Lamp . . . . . . . . . . . . . . . . . . . . . . . . . 3157K.

License Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . 168.

    VEHICLE STORAGE
    If you will not be using your vehicle for more than 21 days you may want to take steps to preserve your battery. You may: • Remove the IOD (Ignition Off-Draw) mini-fuses from the Totally Integra ...

    BULB REPLACEMENT
    Low Beam Headlamp, High Beam Headlamp, Front Turn Signal/Park Lamp, Side Marker Lamp 1. Open the hood. NOTE: It may be necessary to remove the air cleaner filter housing and position the Totally I ...

    See also:

    Draincock, radiator
    Removal DRAINCOCK  Fig. 65: DRAINCOCK & RADIATOR TANK CAUTION: Use of pliers on draincock is not recommended. Damage may occur to radiator or draincock. NOTE: It is no ...

    Seal, input flange
    REMOVAL Fig. 80: Removing /Installing Propeller Shaft NOTE: Rubber coupler is part of the propeller shaft assembly. Removing coupler from propeller shaft will result in vibration/balance i ...

    Standard Procedure
    MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...


    0.3065