Hub and bearing

DESCRIPTION Fig. 31: Front Hub And Bearing Mounting The front wheel bearing and wheel hub of this vehicle are a one piece sealed unit or hub and bearing unit type assembly. The hub and beari ...

Description, Diagnosis and Testing

DESCRIPTION Fig. 38: Front Hub And Bearing Mounting The knuckle (3) is a single casting with legs machined for attachment to the front strut assembly on the top and steering linkage on the trai ...

See also:

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

Lines, A/C underbody, extension
Description Fig. 310: Underbody A/C Extension Lines Description Models equipped with the rear heating-A/C system use metal lines attached to the vehicle underbody to carry refrigerant and engin ...

TO OPEN AND CLOSE THE HOOD
Two latches must be released to open the hood. 1. Pull the hood release lever located under the left side of the instrument panel. Hood Release 2. Outside of the vehicle, locate the safety latch ...