Dodge Journey: Controls, front
Dodge Journey Service & Repair Manual / Heating & Air Conditioning / Controls, front
- Actuator, blend door, front
- Actuator, mode door, front
- Actuator, recirculation door
- Control, A/C and heater, front
- Module, power, front blower motor
- Resistor, blower motor, front
- Sensor, ambient temperature
- Sensor, evaporator temperature
- Sensor, infrared temperature
- Sensor, sun
- Transducer, A/C pressure
Heater performance
Before performing the following tests, see COOLING for the procedures to
check the engine coolant level and
flow, engine coolant reserve/recovery system operation, accessory drive belt
condition ...
See also:
Removal
Fig. 93: Accessory Drive Belt System - 2.7L
- GENERATOR
- IDLER/TENSIONER
1. Perform fuel pressure release procedure before attempting any repairs.
2. Disconnect negative cable from rem ...
Installation
LEFT-HAND DRIVE
1. Clean any debris off the mating surfaces of the HCU and ABM.
CAUTION: When installing new O-rings or solenoid valve stem seals,
do not use
any type of lubricant.
...
Module, power, rear blower motor
DESCRIPTION
Fig. 59: Rear Blower Power Module Description
A blower motor power module is used on this model when equipped with the
automatic temperature control
(ATC) rear heating-A/C system. M ...
