Dodge Journey: Switch, oil pressure
Description
The engine oil pressure switch is located on the right side of the engine block. The switch screws into the engine main oil gallery. The normally closed switch provides an input through a single wire to the low pressure indicator light on the instrument cluster.
Removal
1. Raise vehicle on hoist.
2. Remove heat shield that covers oil pressure switch.
3. Disconnect oil pressure switch electrical connector.
4. Position an oil collecting container under switch location.
5. Remove switch by unscrewing from the engine block.
Installation
1. Apply Mopar Thread Sealant to the switch threads.
2. Install oil pressure switch.
3. Connect electrical connector.
4. Install oil pressure switch heat shield.
5. Lower vehicle.
6. Start engine and check for leaks.
7. Check engine oil level and adjust as necessary.
Pump, engine oil
Removal
Fig. 275: Oil Pump & Pick-up Tube
- BOLTS
- O-RING
- PICK-UP TUBE
- BOLT
- OIL PUMP
NOTE: The oil pump pressure relief valve can be serviced by removing
the oil pan ...
Valve, oil pressure relief
Removal
Fig. 285: Oil Pressure Relief Valve
- RELIEF VALVE
- SPRING
- RETAINER CAP
1. Remove the oil pan.
2. Remove the pressure relief valve (1) by remove the threaded retaining cap ...
See also:
Pan, oil
Removal
Fig. 259: Identifying Oil Dipstick Tube & Bolt
1. Disconnect and isolate the negative battery cable.
2. Remove the bolt (1) and the engine oil dipstick tube (2).
Fig. 260: Belly ...
Removal, Installation
REMOVAL
REMOVAL - NGC CONTROLLER
Fig. 39: Remove/Install PCM
NOTE: USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL
MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER
( ...
Description
The instrument cluster contains the necessary hardware and software to serve
as the vehicle electronic body
control module and is commonly referred to as the Cab Compartment Node (CCN).
The CCN u ...
