Description

Fig. 1: 2.7 Liter Engine The 2.7 Liter (167 Cubic Inches) 60 degree V6 engine is a double overhead camshaft design with hydraulic lifters and four valves per cylinder. The engine does not have p ...

Engine diagnosis

ENGINE DIAGNOSIS - INTRODUCTION Engine diagnosis is helpful in determining the causes of malfunctions not detected and remedied by routine maintenance. These malfunctions may be classified as e ...

See also:

Installation
Fig. 164: Removing/Installing Bellhousing Upper & Lower Bolts NOTE: If transaxle assembly is being replaced or overhauled (clutch and/or seal replacement), it is necessary to perform th ...

Description, standard procedure
DESCRIPTION Fig. 163: Engine Block & Crankshaft - MAIN CAP BOLT-VERTICAL - MAIN CAP - MAIN BEARING-LOWER - MAIN BEARING-UPPER - MAIN CAP BOLT - HORIZONTAL - CYLINDER BLOCK - CRA ...

Seal, output flange
REMOVAL Fig. 93: Axle Seal Removal - SEAL - SCREWDRIVER 1. Raise vehicle on hoist. 2. Remove rear driveline module. 3. Use suitable screwdriver (2) to remove output seal (1). INSTA ...