Dodge Journey: Intermediate shaft, diesel
REMOVAL
2.0L DIESEL
1. Remove the right half shaft.
Fig. 50: 2.0L Diesel Right Half Shaft Components
2. Remove the two intermediate shaft bolts (1).
3. Remove the intermediate shaft (2).
Fig. 51: Intermediate Shaft Bracket & Bolts
4. If necessary, remove the intermediate shaft bracket bolts (1) and the intermediate shaft bracket (2).
INSTALLATION
2.0L DIESEL
Fig. 52: Intermediate Shaft Bracket & Bolts
1. If the intermediate shaft bracket was removed, install the intermediate shaft bracket (2), and the intermediate shaft bracket bolts (1). Tighten the bolts to 23 Nm (17 in. lbs.).
Fig. 53: 2.0L Diesel Right Half Shaft Components
2. Install the intermediate shaft (2).
3. Install the two intermediate shaft bolts (1). Tighten the bolts to 38 Nm (28 in. lbs.).
4. Install the right axle half shaft.
Intermediate shaft, gas
REMOVAL
2.4L
1. Remove the right half shaft.
Fig. 44: Intermediate Shaft - 2.4L
2. Remove the three intermediate shaft bolts (1).
3. Remove the intermediate shaft (2).
2.7L
1. Remove the r ...
Propeller shaft
...
See also:
Lever, shift
REMOVAL
Fig. 183: Air Cleaner And Inlet Tube
Remove the engine cover.
1. Disconnect battery negative cable.
2. Remove air inlet tube (2) and air cleaner assembly (4).
Fig. 184: Nut Crosso ...
Removal
LEFT-HAND-DRIVE
CAUTION: The vacuum in the power brake booster must be pumped down
before
removing the master cylinder to prevent the booster from sucking in any
contamination. This ...
Removal
WARNING: Refer to the applicable warnings and cautions for this
system before
performing the following operation. Failure to follow these instructions
may result in serious or fatal ...
