Installation

NOTE: Perform 1 through 5 on each side of the vehicle to complete pad set installation, then proceed to 6. NOTE: Make sure that the audible wear indicator (if equipped) is placed toward ...

Removal

1. Raise and support vehicle. NOTE: Perform 2 through 5 on each side of vehicle to complete pad set removal. Fig. 124: TIRE AND WHEEL MOUNTING 2. Remove wheel mounting nuts (3), then tire ...

See also:

Seal, oil pump
REMOVAL Fig. 367: Removing Oil Pump Seal - SEAL PULLER C-3981-B - OIL PUMP SEAL 1. Remove transaxle from vehicle. 2. Using Seal Puller C-3981B (1) , remove oil pump seal (2). INSTALLA ...

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructions may result in serious or fat ...

Tube, exhaust gas recirculation (EGR)
Removal 2.7L - LOWER TUBE Fig. 50: Lower Exhaust Gas Recirculation Tube - 2.7L WARNING: The normal operating temperature of the exhaust gas recirculate (EGR) valve and tube is very ...