Installation

LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...

Removal

1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

See also:

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions may result in possible se ...

Removal
1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

Installation
1. Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston before installing the C-clamp to avoid damagi ...