Fluid

Diagnosis and Testing BRAKE FLUID CONTAMINATION Indications of fluid contamination are swollen or deteriorated rubber parts. Swelling indicates the presence of petroleum in the brake fluid. To ...

Description, Operation

DESCRIPTION Fig. 87: PRIMARY AND SECONDARY BRAKE TUBES All master cylinders (2) are a two-outlet design and the brake tubes from these primary and secondary outlet ports lead directly to the In ...

See also:

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

Disassembly
NOTE: The rear heater-A/C housing must be removed from the vehicle for service of the mode door actuator and blend door actuator and it must be disassembled for service of the A/C evaporator ...

Speaker
OPERATION Two wires connected to each speaker, one feed circuit (+) and one return circuit (-), allow the audio output signal electrical current to flow through the voice coil. The wiring informa ...