Installation

LEFT-HAND-DRIVE Fig. 35: BOOSTER SEAL NOTE: Before power brake booster (1) installation, be certain a NEW dash seal (2) is installed on the booster mounting studs. Fig. 36: PEDAL AND ...

Removal

Fig. 56: BRAKE PEDAL HOLDING TOOL 1. Using a brake pedal holding tool as shown, depress the brake pedal past its first one inch (25 mm) of travel and hold it in this position. This will isolate ...

See also:

INSTRUMENT CLUSTER DESCRIPTIONS
1. Coolant Temperature Gauge The temperature gauge indicates engine coolant temperature. Any reading within the normal range indicates that the cooling system is operating satisfactorily. The gaug ...

Installation
Fig. 32: Brake Booster Vacuum Hose 1. Position engine/transaxle assembly under vehicle and slowly lower vehicle in short length spans. Inspect at each interval for potential engine or transaxle ...

Specifications
2.7L ENGINE GENERAL SPECIFICATIONS CYLINDER BLOCK PISTONS PISTON PINS PISTON RINGS PISTON RING SIDE CLEARANCE PISTON RING WIDTH CONNECTING RODS CRANKSHAFT MA ...