Valve, A/C expansion

DESCRIPTION Fig. 315: A/C Expansion Valve Description KA The rear A/C expansion valve controls the amount of refrigerant entering the rear A/C evaporator. The rear A/C expansion valve is of a t ...

Relay, heater unit

DESCRIPTION Fig. 320: Standard ISO-Type Relay Three relays (1) are used for the electric positive temperature coefficient (PTC) heater system when equipped with the 2.0L diesel engine. The rela ...

See also:

Standard procedure
BRAKE ROTOR MACHINING NOTE: Refacing the rotor is not required each time the brake pads are replaced, only when the need is foreseen. Any servicing of the rotor requires extreme care to ma ...

TIRE PRESSURE MONITOR SYSTEM (TPMS)
The Tire Pressure Monitor System (TPMS) will warn the driver of a low tire pressure based on the vehicle recommended cold placard pressure. The tire pressure will vary with temperature by about 1 ...

Ring(s), piston
Standard Procedure PISTON RING FITTING Fig. 200: CHECK GAP ON PISTON RINGS - FEELER GAUGE 1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore ...