Transducer, A/C pressure

DESCRIPTION Fig. 44: A/C Pressure Transducer - A/C PRESSURE TRANSDUCER The A/C pressure transducer (1) is a switch that is installed on a fitting located on the A/C liquid line at the righ ...

Actuator, blend door, rear

DESCRIPTION Fig. 47: Rear Actuator Description The blend door actuator (1) for the rear heating-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear blend door actuato ...

See also:

Standard procedure
ENGINE GASKET SURFACE PREPARATION Fig. 4: PROPER TOOL USAGE FOR SURFACE PREPARATION To ensure engine gasket sealing, proper surface preparation must be performed, especially with the use of alu ...

Removal
1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

With intermediate shaft
NOTE: Never grasp the halfshaft assembly by the inner or outer boots. This can cause damage to the boot, which will allow contaminants to enter the C/V joint. NOTE: The inner tripod joints ...