Installation

Fig. 28: Sealing Boot Installation on Interconnecting Shaft - SEALING BOOT - RAISED BEAD IN THIS AREA OF SEALING BOOT - GROOVE - INTERCONNECTING SHAFT 1. Slide new sealing boot clamp (2 ...

Description, Diagnosis and Testing

DESCRIPTION The inner joints of both half shaft assemblies are tripod joints. The outer joints of both assemblies are Rzeppa Joints. The tripod joints are true constant velocity (CV) joint assembl ...

See also:

ELECTRICAL POWER OUTLETS
There are two fused 12 Volt (13 Amp) power outlets located in the center console below the radio. The power outlet on the top has power available when the ignition switch in the ON or ACC position. ...

Warning, Caution
WARNING WARNING: The A/C system contains refrigerant under high pressure. Repairs should only be performed by qualified service personnel. Serious or fatal injury may result from ...

Seal, output flange
REMOVAL Fig. 93: Axle Seal Removal - SEAL - SCREWDRIVER 1. Raise vehicle on hoist. 2. Remove rear driveline module. 3. Use suitable screwdriver (2) to remove output seal (1). INSTA ...