Electrical

SWITCH, BRAKE FLUID LEVEL Description The brake fluid level switch (2) is mounted through the center of the fluid reservoir. The switch can be serviced separately from the master cylinder fluid r ...

Description

Four-wheel disc brakes are standard on this vehicle. Each disc brake assembly consists of the following major components: Caliper Caliper adapter bracket Pads (Shoe and lining assemblies) ...

See also:

Installation
LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...

Assembly
Fig. 257: Installing Input Shaft - INPUT SHAFT - ARBOR PRESS - INPUT SHAFT HUB ASSEMBLY Use petrolatum on all seals to ease assembly of components. 1. Using an arbor press (2), install ...

Description, Diagnosis and Testing
Description Fig. 17: PEDAL AND BOOSTER MOUNTING - LHD The power brake booster (3) is mounted to the engine side of the dash panel. The master cylinder is bolted to the front of the booster. A v ...