Reservoir, brake master cylinder

Removal CAUTION: If at any time the master cylinder is loosened or removed, you must perform the master cylinder installation procedure to ensure that the seal (o-ring) is still ...

Diagnosis and Testing

BRAKE ROTOR Any servicing of the rotor requires extreme care to maintain the rotor within service tolerances to ensure proper brake action. Excessive runout or wobble in a rotor can increase pe ...

See also:

Actuator, blend door, rear
DESCRIPTION Fig. 47: Rear Actuator Description The blend door actuator (1) for the rear heating-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear blend door actuato ...

Operation
The left (lighting) multi-function switch uses resistor multiplexing to control the many functions and features it provides using a minimal number of hard wired circuits. The switch receives clea ...

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...