Dodge Journey: Caliper, disc brake, rear

Installation
1. Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston before installing the C-clamp to avoid damagi ...

Removal
1. Disconnect and isolate battery negative cable from battery post. Fig. 70: BRAKE PEDAL HOLDING TOOL 2. Using a brake pedal holding tool as shown, depress brake pedal past its first inch of tra ...

See also:

ELECTRICAL POWER OUTLETS
There are two fused 12 Volt (13 Amp) power outlets located in the center console below the radio. The power outlet on the top has power available when the ignition switch in the ON or ACC position. ...

Description
The base brake system consists of the following components: Brake pedal Power brake booster Master cylinder Brake tubes and hoses Disc brakes (four-wheel) Brake lamp switch Brake fluid ...

Description, Operation, Diagnosis and Testing
DESCRIPTION The lubrication system is a full-flow filtration, pressure feed type. The oil pump body is mounted to the engine block. The pump inner rotor is driven by the crankshaft. A structural w ...

1.4048