Description

Four-wheel disc brakes are standard on this vehicle. Each disc brake assembly consists of the following major components: Caliper Caliper adapter bracket Pads (Shoe and lining assemblies) ...

Description, Diagnosis and Testing

Description Fig. 17: PEDAL AND BOOSTER MOUNTING - LHD The power brake booster (3) is mounted to the engine side of the dash panel. The master cylinder is bolted to the front of the booster. A v ...

See also:

Installation
Fig. 40: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install halfshaft to hub/bearing assembly. Install hub nut and washer but do not tighten at this time. 2. Using Seal Protector 9 ...

Installation
Fig. 164: Removing/Installing Bellhousing Upper & Lower Bolts NOTE: If transaxle assembly is being replaced or overhauled (clutch and/or seal replacement), it is necessary to perform th ...

Removal
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow these instructions may result in serious or fatal ...