Frame and Bumpers

...

Fascia, front

REMOVAL Fig. 1: Pushpins 1. Release hood latch and open hood. 2. Remove the pushpins for the fascia (2) at the radiator support. Fig. 2: Pop Rivets 3. Hoist and support vehicle on safety st ...

See also:

Removal, Installation
REMOVAL REMOVAL - NGC CONTROLLER Fig. 39: Remove/Install PCM NOTE: USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER ( ...

Solenoid, evaporative emissions purge
Operation During the cold start warm-up period and the hot start time delay, the PCM does not energize the solenoid. When de-energized, no vapors are purged. The proportional purge solenoid o ...

Toe
Fig. 115: Steering Wheel Holding Tool 1. Center the steering wheel and lock it in place using a steering wheel clamp. NOTE: When setting toe, make sure to set rear toe to the preferred spe ...