Installation

LEFT-HAND-DRIVE Fig. 35: BOOSTER SEAL NOTE: Before power brake booster (1) installation, be certain a NEW dash seal (2) is installed on the booster mounting studs. Fig. 36: PEDAL AND ...

Removal

Fig. 56: BRAKE PEDAL HOLDING TOOL 1. Using a brake pedal holding tool as shown, depress the brake pedal past its first one inch (25 mm) of travel and hold it in this position. This will isolate ...

See also:

Description, Operation
DESCRIPTION Fig. 1: Battery Components This vehicle is equipped with a single 12-volt battery. All of the components of the battery system are located in the front of the vehicle, just ahead of ...

Valve, exhaust gas recirculation (EGR)
Description The EGR valve consists of three major components. First there is the pintle, valve seat, and housing which contains and regulates the gas flow. Second there is the armature, return s ...

Removal
Fig. 393: Removing/Installing Defroster Cover 1. Disconnect the negative battery cable. 2. Using a trim stick remove the defroster cover (1). Fig. 394: Removing/Installing Screws At Center St ...