Dodge Journey: Horn
REMOVAL
Fig. 1: Removing / Installing Horns
1. Disconnect and isolate the negative battery cable.
2. Remove the push pin type retainers along the top of the grille assembly and position the grille aside.
3. Disconnect the wire harness connectors (3) from the horns (2).
4. Remove mounting bolt (1) securing the horn bracket and remove horns.
INSTALLATION
Fig. 2: Removing / Installing Horns
1. Install the horn assemblies (2).
2. Install the horn mounting bolt (1).
3. Connect the wire harness connector (3).
4. Position the grille and install the retainers.
5. Connect the negative battery cable.
Description, Operation, Diagnosis and Testing
DESCRIPTION
The dual-note horn system features two electromagnetic horn units. The horn
system includes the following
major components:
Horn - The two horns are located at the front center of ...
Switch, horn
REMOVAL
WARNING: On vehicles equipped with an airbag, refer to Restraint
SERVICE
INFORMATION article for warnings and cautions before servicing the horn
switch.
Fig. 3: Remov ...
See also:
Installation
1. Guide the trailing end of the parking brake cable along the inboard side
of the axle trailing arm up to the
rear brake caliper. Make sure the cable is routed between the brake line and the
tra ...
Tray, battery
DESCRIPTION
The battery is placed and secured in a stamped steel battery tray. The
battery tray is located in the left front side
of the vehicle, just ahead of the left front wheel and tire assemb ...
Insulator, engine mount, right
Removal
Fig. 243: Belly Pan
1. Remove the belly pan (2).
Fig. 244: Right Engine Mount
2. Lower vehicle. Remove the load on the engine motor mounts by carefully
supporting the engine assembly ...
