Dodge Journey: LIFTGATE

The liftgate can be unlocked or locked with the Remote Keyless Entry (RKE) transmitter or by activating the power door lock switch located on either front door trim panel.

NOTE: The liftgate cannot be unlocked or locked with the manual door lock plungers on the door trim panels or the door lock cylinder on the driver’s door.

To open the unlocked liftgate, squeeze the handle and pull the liftgate toward you. Gas props will raise and support the liftgate in the open position.

Liftgate Release
Liftgate Release

NOTE: Because the gas pressure drops with temperature, it may be necessary to assist the props when opening the liftgate in cold weather.

WARNING:
• Driving with the liftgate open can allow poisonous exhaust gases into your vehicle. These fumes could injure you and your passengers. Keep the liftgate closed when you are operating the vehicle.

• If you are required to drive with the liftgate open, make sure that all windows are closed, and the blower switch on the climate control is set at high speed. DO NOT use the recirculation mode.

    WINDOWS
    Power Windows The window controls on the driver’s door trim panel control all of the door windows. Power Window Switches There are single window controls on each passenger door trim panel, wh ...

    OCCUPANT RESTRAINTS
    Some of the most important safety features in your vehicle are the restraint systems: • Three-point lap and shoulder belts for all seating positions. • Advanced Front Airbags for driver and fr ...

    See also:

    Operation
    SYSTEM The Powertrain Control Module (PCM) monitors many different circuits in the fuel injection, ignition, emission and engine systems. If the PCM senses a problem with a monitored circuit often ...

    Cable, shift
    REMOVAL Fig. 306: Identifying Knee Blocker 1. Remove the knee blocker (2). Fig. 307: Identifying Shift Cable At Shifter NOTE: Ensure the lock tab on the shift cable (2) is depressed before ...

    Seal, output flange
    REMOVAL Fig. 93: Axle Seal Removal - SEAL - SCREWDRIVER 1. Raise vehicle on hoist. 2. Remove rear driveline module. 3. Use suitable screwdriver (2) to remove output seal (1). INSTA ...

    0.0117