Installation

Fig. 97: Strut Upper Mounting Nuts 1. Raise the strut assembly (2) into the strut tower, aligning the three studs on the strut assembly upper mount with the holes in strut tower. Install the thr ...

Description

Vehicle wheel alignment is the positioning of all interrelated front and rear suspension angles. These angles affect the handling and steering of the vehicle when it is in motion. Proper wheel al ...

See also:

Standard procedure
PCM/ECM REPROGRAMMING - GAS Follow the instructions in order. OBTAINING DIAGNOSTIC TROUBLE CODES BULB CHECK Key on: Bulb illuminated until vehicle starts, as long as all once per trip (readiness ...

Fluid
STANDARD PROCEDURE FLUID LEVEL CHECKING The fluid required for this transaxle is Mopar ATF+4 (Automatic Transmission Fluid). Use of improper or substitute fluids can cause shift problems and/or t ...

ELECTRICAL POWER OUTLETS
There are two fused 12 Volt (13 Amp) power outlets located in the center console below the radio. The power outlet on the top has power available when the ignition switch in the ON or ACC position. ...