Dodge Journey: Description, Operation, Diagnosis and Testing

Dodge Journey Service & Repair Manual / Engine / 2.7L DOHC Engine / Lubrication / Description, Operation, Diagnosis and Testing

DESCRIPTION

The lubrication system is a full-flow filtration, pressure feed type. The oil pump body is mounted to the engine block. The pump inner rotor is driven by the crankshaft. A structural windage tray is used to increase power by minimizing oil windage at high engine RPM. An engine oil cooler is used on some models.

OPERATION

Oil from the oil pan is pumped by a gerotor type oil pump (3) directly coupled to the crankshaft. Oil pressure is controlled by a relief valve mounted inside the oil pump housing.

2.7L DOHC Engine
Fig. 247: Cylinder Block Oil Lubrication System

  1. - TO RIGHT CYLINDER HEAD
  2. - TO LEFT CYLINDER HEAD
  3. - OIL PUMP
  4. - OIL PICKUP TUBE
  5. - OIL FILTER
  6. - TO CRANKSHAFT MAIN JOURNALS
  7. - MAIN OIL GALLERY

2.7L DOHC Engine
Fig. 248: Cylinder Head Oil Lubrication System - Left Side

  1. - CAM JOURNALS
  2. - OIL FEED TO CAMSHAFT (SECONDARY) CHAIN TENSIONER
  3. - LASH ADJUSTER BORES
  4. - OIL FEED FROM BLOCK
  5. - VENT HOLE
  6. - ACCUMULATOR

2.7L DOHC Engine
Fig. 249: Cylinder Head Oil Lubrication System - Right Side

  1. - OIL FEED TO CAMSHAFT (SECONDARY) CHAIN TENSIONER
  2. - OIL FEED TO TIMING CHAIN (PRIMARY) TENSIONER
  3. - CAM JOURNALS
  4. - ACCUMULATOR
  5. - VENT HOLE
  6. - OIL FEED FROM BLOCK
  7. - LASH ADJUSTOR BORES

DIAGNOSIS AND TESTING

CHECKING ENGINE OIL PRESSURE

1. Remove the oil pressure switch.

2. Install oil pressure test gauge assembly, Special Tools C-3292A with 8406 adaptor.

3. Start engine and monitor gauge readings.

CAUTION: If oil pressure is 0 at idle, Do Not Run engine at 3000 RPM

4. Oil Pressure (engine at operating temperature): Curb Idle 34.5 kPa (5 psi) minimum 3000 RPM 300-724 kPa (45-105 psi).

5. If oil pressure is 0 at idle. Shut off engine, check for pressure relief valve stuck open or a clogged oil pickup screen.

6. Install oil pressure switch after testing is completed.

    Cooler and lines, oil
    Description Fig. 250: Oil Cooler Fasteners Some 2.7L engines may be equipped with an engine oil cooler (2) that is mounted to the rear transmission mount bracket. Oil lines route oil from the e ...

    See also:

    Description
    The instrument cluster contains the necessary hardware and software to serve as the vehicle electronic body control module and is commonly referred to as the Cab Compartment Node (CCN). The CCN u ...

    CLIMATE CONTROLS
    The Climate Control System allows you to regulate the temperature, amount, and direction of air circulating throughout the vehicle. The controls are located in the center stack of the instrument pa ...

    Removal, Installation
    REMOVAL Fig. 54: Removing /Installing Propeller Shaft CAUTION: Propeller shaft removal is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while o ...


    0.0186