Installation

NOTE: Perform 1 through 6 on each side of vehicle to complete pad set installation, then proceed to 7. CAUTION: Anytime the brake rotor or brake pads are being replaced, the rear cal ...

Removal

LEFT-HAND-DRIVE 1. Disconnect and isolate the battery negative cable from its post on the battery. 2. If equipped, remove the silencer pad below the steering column opening cover. Fig. 132: S ...

See also:

Description, Diagnosis and Testing
DESCRIPTION Fig. 91: Cylinder Head, Valves & Springs - VALVE KEEPER - SPRING RETAINER - VALVE KEEPER - VALVE SPRING-EXHAUST - SPRING RETAINER - VALVE STEM SEAL - VALVE-EXHAUST ...

Removal, Installation
REMOVAL Fig. 298: Identifying Transmission Connectors - SOLENOID PACK CONNECTOR - INPUT SPEED SENSOR CONNECTOR - OUTPUT SPEED SENSOR CONNECTOR - TRANSMISSION RANGE SENSOR CONNECTOR ...

Installation
Fig. 137: Rear Mount Bracket 1. If transmission brackets were removed or transmission was replaced install the rear mount bracket and tighten (1) to 100 N.m (74 ft. lbs.). Fig. 138: Front Mou ...