Installation

Fig. 97: Strut Upper Mounting Nuts 1. Raise the strut assembly (2) into the strut tower, aligning the three studs on the strut assembly upper mount with the holes in strut tower. Install the thr ...

Description

Vehicle wheel alignment is the positioning of all interrelated front and rear suspension angles. These angles affect the handling and steering of the vehicle when it is in motion. Proper wheel al ...

See also:

Installation
1. Completely retract the caliper piston back into the bore of the caliper. Use a C-clamp to retract the piston. Place a wood block over the piston before installing the C-clamp to avoid damagi ...

Description, Operation
DESCRIPTION Fig. 7: Blend Door Actuators The blend door actuators (1) for the front heating-A/C system are reversible, 12-volt direct current (DC) servo motors. Models with the front single zon ...

Removal
Fig. 93: Accessory Drive Belt System - 2.7L - GENERATOR - IDLER/TENSIONER 1. Perform fuel pressure release procedure before attempting any repairs. 2. Disconnect negative cable from rem ...